Menu 2.3 Vra/Remote Control; Variable Rate Application (Vra) / Remote / Hardi® Autosectioncontrol - Hardi HC6500 Instruction Book

Menu 2.3 VRA/Remote control

Variable Rate Application (VRA) / Remote / HARDI® AutoSectionControl
If the volume rate is to come from an external source (e.g. a site specific application map or a remote sensor), this menu has
to be enabled. This is done by selecting one of the submenus:
Menu 2.3.1 Disable
Menu 2.3.2 Enable
The Πsymbol on the 1st line will be visible. Manual pressure regulation and stepped over/under application is still possible.
The external source is connected to the COM 1 or COM 2 via a 9 pin sub D connector.
±
ATTENTION! The COM port may have to be set up in the extended menu. Contact your HARDI® service center.
μ
ATTENTION! Use of HARDI® AutoSectionControl requires a sprayer equipped with JobCom computer. If in doubt
whether your sprayer has a JobCom installed, please contact your local HARDI® dealer.
μ
ATTENTION! AutoSectionControl also uses Variable Rate Application when connected to RS 232 port on the Terminal.
6 - Menu 2 Setup
6.5