Set Parameters - Vega VEGADIF 65 Operating Instructions Manual

Adjustment system
Introduction
Applications
VEGADIF 65 • 4 ... 20 mA
6 Adjustment with the display and adjustment module PLICSCOM
– Save value
•
[->] key to select:
– Menu change
– Select list entry
– Select editing position
•
[+] key:
– Change value of the parameter
•
[ESC] key:
– interrupt input
– Jump to next higher menu
The sensor is adjusted via the four keys of the display and adjust-
ment module. The LC display indicates the individual menu items. The
functions of the individual keys are shown in the above illustration.
Approx. 10 minutes after the last pressing of a key, an automatic reset
to measured value indication is triggered. Any values not confirmed
with [OK] will not be saved.
6.4

Set parameters

VEGADIF 65 has general adjustment parameters which are also
used for other measuring principles as well as instrument-specific
adjustment parameters. The general adjustment parameters are
described in the operating instructions manual "Display and adjust-
ment module".
The instrument-specific adjustment parameters are described in this
chapter.
Information:
If the adjustment limits of the adjustment parameters are exceeded,
the message "Outside parameter limits" appears. The editing proce-
dure can be aborted with [ESC] or the displayed limit value can be
accepted with [OK].
The VEGADIF 65 can be used for differential pressure, level, flow
as well as density and interface measurement. The selection of the
respective application is carried out in the menu item "Application".
Dependent on the selected application, the adjustment is carried out
as zero/span or min./max. adjustment.
Information:
The applications density and interface measurement are also realized
via the application level measurement.
Proceed as follows to switch over to the application differential pres-
sure or flow measurement:
1. Push the [OK] button in the measured value display, the menu
overview is displayed.
41