Set Parameters - Vega VEGADIF 65 Operating Instructions Manual

6 Adjustment with the display and adjustment module PLICSCOM
Adjustment system
Time functions
Introduction
Basic adjustmen - Ap-
plication
44
– Move to the menu overview
– Confirm selected menu
– Edit parameter
– Save value
•
[->] key to select:
– Menu change
– Select list entry
– Select editing position
•
[+] key:
– Change value of the parameter
•
[ESC] key:
– Interrupt input
– Jump to next higher menu
The instrument is operated via the four keys of the display and adjust-
ment module. The individual menu items are shown on the LC display.
You can find the functions of the individual keys in the previous
illustration.
When the [+] and [->] keys are pressed quickly, the edited value,
or the cursor, changes one value or position at a time. If the key is
pressed longer than 1 s, the value or position changes continuously.
When the [OK] and [ESC] keys are pressed simultaneously for more
than 5 s, the display returns to the main menu. The menu language is
then switched over to "English".
Approx. 60 minutes after the last pressing of a key, an automatic reset
to measured value indication is triggered. Any values not confirmed
with [OK] will not be saved.
6.4

Set parameters

VEGADIF 65 has general adjustment parameters which are also
used for other measuring principles as well as instrument-specific
adjustment parameters. The general adjustment parameters are
described in the operating instructions manual "Display and adjust-
ment module".
The instrument-specific adjustment parameters are described in this
chapter.
Information:
If the adjustment limits of the adjustment parameters are exceeded,
the message "Outside parameter limits" appears. The editing proce-
dure can be aborted with [ESC] or the displayed limit value can be
accepted with [OK].
The VEGADIF 65 can be used for differential pressure, level, flow
as well as density and interface measurement. The selection of the
respective application is carried out in the menu item "Application".
Dependent on the selected application, the adjustment is carried out
as zero/span or min./max. adjustment.
VEGADIF 65 • 4 ... 20 mA