Vega VEGADIF 65 Operating Instructions Manual page 48

6 Adjustment with the display and adjustment module PLICSCOM
Total amounts counter
and subtotalizer with flow
Copy sensor data
48
differential pressure cause big changes in the output signal. The leak
volume suppression stabilises the signal output.
The VEGADIF 65 has two internal totalizers. For both you can adjust
volume or mass as count function as well as separately the unit.
Proceed as follows:
1. Select, for example, menu item "Part sum counter".
Part sum counter
0.0000 10
00
gal
Modify settings?
2. Activate the function "Modify settings?" with [OK].
Part sum counter
▶
Effective pressure transmitter
Unit
3. Confirm with [OK] "Effective pressure transmitter".
Part sum counter
▶
Mass flow
▶
Volume flow
Without unit
4. Select the requested variable with [->] and confirm with [OK].
5. Select calibration unit of the effective pressure transmitter with
[->], for example m
Part sum counter
0 % = +0000
m /s=
3
100 % = +0000
m /s=
3
6. Edit with [OK] and set the requested values with [+] and [->].
7. Confirm with [OK] and jump back to the indication of the part sum
counter.
8. Select with [->] the unit of the sum counter, adjust the requested
unit with [->], for example m
The setting of the part sum counter is hence terminated, the counting
function is activated.
The procedure of the total sum counter is the same.
This function enables uploading parameter adjustment data into the
display and adjustment module as well as downloading parameter
adjustment data into the sensor. A detailed description of the function
is available in the operating instructions manual "Display and adjust-
ment module".
The following data are loaded or downloaded with this function:
•
Measured value presentation
•
Applications
•
Adjustment
/s and confirm with [OK].
3
/s and confirm with [OK].
3
VEGADIF 65 • 4 ... 20 mA