1205 [Avoid Paper Transfer Shock Jitter: Feed Interval]; 1206 [Fusing Temperature] - Ricoh Pro 8300S Operating Instructions Manual

4. Details of Menu Items in Advanced Settings
Setting Item
01: Leading Edge/02: Trailing Edge
03: Leading Edge Length
04: Trailing Edge Length

1205 [Avoid Paper Transfer Shock Jitter: Feed Interval]

Set whether to extend the paper feed interval.
If [On] is selected, the machine adjusts the interval between sheets to reduce jitter. However, the
throughput may be reduced when you use paper larger than A4 or 8
select [Off] to improve the throughput.
• Jitter does not occur with A4 , 8
01: Setting

1206 [Fusing Temperature]

Fusing Temperature
Heat Roller Temp
Adjust the temperature of heat roller.
Press [ ] to increase the temperature and [ ] to reduce it.
• Decreasing the temperature too much may cause the toner to not properly fuse to the paper
(cold offset).
• Increasing the temperature too much may distort the paper and cause glossy lines, paper
jams, and insufficient toner fusing (hot offset).
• Depending on the type of paper, you can increase the toner gloss by increasing the
temperature by 5 to 10°C over the initial factory setting.
128
1
/ × 14 or smaller paper.
2
Setting Item
Max. Value Min. Value
300 0
30 0
100 0
1
/
2
[Off]
[On]
Step Unit
1 %
1 mm
1 mm
14 . In such a case,
Values