0212 [Productivity Priority Mode]; 0213 [Continuous Slip Sheet Feed Mode] - Ricoh Pro 8300S Operating Instructions Manual

0212 [Productivity Priority Mode]

Set the image area ratio threshold of toner refreshing mode.
After printing on the thick paper, the machine usually stops so that the fusing temperature decreases
before printing on the thin paper.
If you specify [Productivity Priority] for this setting, the machine will print non-stop so that the fusing
temperature does not decrease. This increases throughput and the job will complete quicker.
However, it might result in uneven print quality on the thin paper.
Setting Items
[Setting]

0213 [Continuous Slip Sheet Feed Mode]

Set the stop of imaging unit with continuous slip sheet feed mode.
Continuous slip sheet feeding causes the imaging unit to run idle, causing image problems including
tonner dispersion, scumming, streaks, uneven gloss, and gloss streaks. You can avoid such problems by
stopping the imaging unit while the inserter is running.
Setting [Stop Imaging Unit] to [On] will cause a delay because the imaging unit is stopped after it is
started.
Use this option if you want to avoid the above-described image problems when continuously feeding
slip sheets.
Setting Items
[Stop Imaging Unit]
When this is set to [On], specify the number of slip sheets to be continuously fed before the imaging unit
is stopped.
Setting Items
[No. of Sheets to Stop Imaging Unit]
Values
[Fusing Priority]
[Normal]
[Productivity Priority]
Values
[Off]
[On]
Default Max.
Value Value
10 99
[Main Unit: Image Quality]
Default Value
[Normal]
Default Value
[Off]
Min.
Step
Value
1 1 Sheet(s)
Unit
35