1209 [Fusing Cleaning]; 1210 [Erase Margin] - Ricoh Pro 8300S Operating Instructions Manual

Start Time of Pressure Before Feed
Adjust the timing for the fusing pressure roller to come into contact with the fusing belt before the printing
operation (paper feeding) starts.
Once a job starts, the fusing pressure roller comes into contact with the fusing belt after the time specified
in this setting has elapsed.
If this is set to 30 seconds, the fusing pressure roller comes into contact with the fusing belt 30 seconds
after a job starts, and printing starts once warm-up is complete (when the temperature at which paper
feeding is allowed is reached).
Use this to adjust the fusibility and reduce image degradation (such as uneven luster and blisters).
If you reduce the starting time, the temperature drop the machine is able to handle can be increased, but
uneven luster may occur.
If you increase the starting time, the temperature drop the machine is able to handle is reduced, but
uneven luster is reduced.
Press [ ] or [ ] to adjust the start timing.
Setting Item
02: Setting

1209 [Fusing Cleaning]

Specify the interval between each activation of the cleaning web.
You can remove stains from the fusing pressure roller by reducing the interval between each activation
of the cleaning web. However, doing this causes the cleaning web to wear out faster, resulting in more
frequent replacement. If you set this to "0.01", cleaning is always performed during paper feeding.
Press [ ] to increase the interval and [ ] to reduce it.
Setting Item
01: Cleaning Interval

1210 [Erase Margin]

Leading Edge
Adjust the mask width at the leading edge of the image.
By increasing the mask width, you can increase the paper margin at the leading edge of the paper.
Press [ ] to increase the mask width and [ ] to reduce it
Max. Value Min. Value
500.0 0.0
Max. Value Min. Value
3.00 0.01
[Machine: Image Quality]
Step Unit
0.1 sec
Step Unit
0.01 None
131