Ricoh Pro 8300S Operating Instructions Manual page 131

Corct Temp: Initial Feed / Corct Temp: Pre-Feed
Adjust the temperature to be added at the beginning of the paper feed.
Press [ ] to increase the temperature and [ ] to reduce it.
Setting Item
01: Heat Roller Temp
02: Corct Temp: Initial Feed/03: Corct
Temp: Pre-Feed
Reduce Initial CPM
Low Temperature
Select one of the three levels of initial print speed reduction at low temperatures.
The selected initial print speed reduction level in copies-per-minute (CPM) is applied only when
printing starts (for approximately 15 to 20 seconds).
This helps improve throughput if the fusing temperature can be kept constant. However, the
throughput may decrease in an environment in which the temperature varies.
• The setting will take effect if the ambient temperature is 17°C (62.6°F) or lower. Since the
temperature of the fusing unit may decrease in a cold environment, specify this setting in
addition to [Normal/High Temperature].
Normal/High Temperature
Select one of the three levels of initial print speed reduction at normal room temperatures and
above.
The selected initial print speed reduction level in copies-per-minute (CPM) is applied only when
printing starts (for approximately 15 to 20 seconds).
This helps improve throughput if the fusing temperature can be kept constant. However, the
throughput may decrease in an environment in which the temperature varies.
• The setting will take effect if the ambient temperature is higher than 17°C (62.6°F).
Max. Value Min. Value
200 100
30 0
[Machine: Image Quality]
Step Unit
1 deg
1 deg
129