Erasing Colors - Ricoh Pro C7100s Operating Instructions Manual

3. Color Copying
6. Select the color to be converted.
7. Select the new color.
You can adjust the density of the color in four steps.
To select user color, press [User Color], and then select the color.
To change two colors or more, repeat Steps 5 to 7.
8. Press [OK] three times.
9. Place the originals, and then press the [Start] key.
• The full color counter values will increase.
• The width of the color to be converted can be adjusted in five levels. When the width of the color is
set to [Wider] under [Color Sensitivity] in User Tools and red has been specified, colors close to
orange and purple will be converted. You can change the setting. For details, see page 251
"Adjust Color Image".
• User colors should be registered in advance. For details about how to register a user color, see
page 107 "Registering User Colors".

Erasing Colors

Copies by erasing a certain color in the image of the original.
This function can be used when [Full Color] or [Black & White] is selected in the color mode.
98
CKN107