Preparing The Appliance; Rinsing Of Circuits - Rowenta AUTOMATIC Manual

At each stage you can memorise settings by pressing the
or continue the procedure. If no other setting is made in the next 30 seconds, the lights will go off and the
settings shown will be recorded. The settings will remain memorised even if there is a power failure.
You can change these settings at anytime by repeating the same operations.

PREPARING THE APPLIANCE

Pull out and fill the
water tank.
Do not fill the water tank with hot water, milk or any other liquid. If you turn on the appliance
when the water tank is not in place or not correctly filled (under the "min." level,), the "fill water
tank" light will come on and making an espresso or a cup of coffee will be made impossible.
NEVER PUT GROUND COFFEE IN THE COFFEE CONTAINER.
It is recommended that you do not use oily, caramelised or flavoured coffee beans for this machine.
These kinds of beans may damage the machine.
Check that the coffee beans do not contain any foreign particles such as grit, as any damage caused
by the presence of foreign particles will negate the guarantee.
Do not put water into the coffee bean container.
Remember to fit the drip tray to avoid waste water flowing onto the work surface and staining it or
scalding you. Check that your water tank is clean.

RINSING OF CIRCUITS

Turn the appliance on by pressing
the button.
The light will flash during the
pre-heating and initialisation cycle.
It is preferable to rinse the 2 circuits out at least once after the machine has not been used for several
days. Each time you plug your machine in, it will carry out an initialisation cycle.
Put it back in place by
pressing firmly and
close the lid again.
1 s
Rinsing out the coffee circuit:
Place a container under the coffee
nozzles. Press the 'Service' button
quickly to start a coffee circuit rin-
sing cycle, which will automatically
stop after around 40 ml.
key if you have finished setting satisfactorily
Open the coffee
bean container lid.
Add the coffee beans
(250 g maximum).
Rinsing out the steam circuit:
Place a container under the steam
nozzle and press the 'Service'
button for 3 seconds to start a
steam circuit rinsing cycle, which
will automatically stop after
around 300 ml.
6
GB
Close the coffee
bean container lid
again.