Troubleshooting, Corrective Actions - Rowenta AUTOMATIC Manual

TROUBLESHOOTING, CORRECTIVE ACTIONS

The appliance does not turn on
after I press the
GB
Water or steam are coming out of
the steam nozzle unexpectedly.
The espresso or coffee is not hot
enough.
The coffee is too weak or not
strong enough.
The coffee flows too slowly.
The coffee is not creamy enough.
The machine has not produced
any coffee.
You used ground coffee instead of
coffee beans.
The grinder makes a strange noise.
The grinding fineness button is dif-
ficult to turn.
Steam does not come out of the
nozzle.
Check that the power supply cord plug is correctly inserted
button. in the socket.
If used often, some drops of water may run out of the steam
nozzle.
Change the coffee temperature setting.
Heat the cups by rinsing them under hot water.
Check that the coffee bean compartment contains coffee and
that it is running through properly.
Avoid using oily, caramelised or flavoured coffee beans.
Reduce the volume you have selected using the knob.
Select the
Turn the fineness of grind button to the left to obtain a finer
grind.
Make your coffee in two separate cycles by using the 2 cup
function.
Turn the fineness of grind button to the right to obtain a co-
arser grind (may depend on the kind of coffee being used).
Carry out one or more rinsing cycles.
Turn the grinding fineness knob towards the left for a finer
grind (may depend on the type of coffee used).
Change the Claris Aqua Filter System cartridge (follow the
installation procedure on page 4).
Carry out one or two rinsing cycles.
An incident has been detected during the coffee making process.
The machine automatically re-initialises and is ready for a
new cycle.
Use your vacuum cleaner to remove the ground coffee in the
coffee bean container.
There are foreign particles in the grinder.
Contact your Rowenta helpline.
Only adjust the grinder when it is operating.
After switching off your appliance and leaving it to cool:
Make sure the tip of the steam nozzle is properly affixed.
Make sure the steam nozzle is not clogged at the aerator (if
necessary clean the steam nozzle aerator with the needle sup-
plied). Empty the tank and remove the Claris filter. Fill the tank
with mineral water high in calcium (> 100 mg/litre or
.015oz/gallon), it may take as many as 5 to 10 cycles of steam
at 60 seconds each cycle to achieve a continuous jet of steam.
Once you have a continuous jet of steam you should not have
to use this particular type of water again.
button.
15