Setting Up The Auto-Cappuccino Xs 6000 - Rowenta AUTOMATIC Manual

GB
To remove any
remaining milk from
the steam nozzle,
place a container
under the nozzle and
press the key.
To interrupt the steam function, just press any key. Be careful as the nozzle may be hot.
If the nozzle is blocked, unblock it using the needle supplied.
The maximum duration for production of steam per cycle is limited to 2 minutes.

SETTING UP THE AUTO-CAPPUCCINO XS 6000

(SOLD SEPARATELY)
This auto-cappuccino accessory makes it easier to make a cappuccino or a caffe latte.
XS 6000
Attach the various
parts together.
The tube must not be twisted to ensure that the selector is in the correct position.
To prevent milk from drying on the auto-cappuccino accessory, it must be cleaned thoroughly. It is
recommend that you wash it immediately by carrying out a cycle with steam and the accessory
pot filled with water in order to clean the inside of the nozzle. To do so, you can use liquid cleaner
XS4000, available as an accessory.
Let the steam escape
for at least 10 seconds
and then again press
the key to stop the
process.
Select the cappuccino Fill up the milk pot
or caffe latte position and place a cup or a
on the special nozzle. glass underneath the
auto-cappuccino
nozzle.
The steam nozzle can be removed for more intense cleaning.
Wash it out with water and a little washing up liquid and a small
non-abrasive brush. Rinse and dry it. Before putting it back,
ensure that the air inlet holes are not blocked by any milk
residues. If necessary, unblock them using the needle supplied.
Do not wash the steam nozzle in the dishwasher.
Press the
button to start and
then to stop the
cycle
9
Place your cup under
the coffee outlets
and start a coffee /
espresso cycle.