Table of Contents
Advertisement
Not enough froth on the milk.
The milk froth is too bubbly.
The Auto-Cappuccino accessory
does not suck up the milk (acces-
sory sold separately).
The cleaning or descaling program
will not start.
After having filled the water tank,
the
light remains on.
After having emptied the coffee
grounds collector, the
mains on.
A power failure occurred during a
cycle.
There is water or coffee under the
appliance.
The 4 red lights flash permanently.
HELPLINE:
If you have any product problems or queries, please contact our Customer Relations Team first for
expert help and advice:
Using the needle supplied unblock the small air inlet at the
top of the nozzle if required.
Use a cold container and very fresh, very cold semi-skimmed
and milk that has been opened recently.
Try changing the type of milk if this does not work try UHT
milk or skimmed milk.
Check that the 2 ends of the small stainless steel tube in the
flexible part of the steam nozzle are fitted together properly.
Check that the tube that goes into the milk is not blocked.
Check that the flexible tube is not twisted and that it is cor-
rectly fitted into the accessory to avoid any air being sucked
in.
After having turned the machine off and left it to cool, unblock
the outlet of the Auto-Cappuccino accessory.
These programs are only possible when the machine
requests them ('clean' or 'calc' light on).
Check for correct positioning of the tank in the coffee maker.
Check that the float at the bottom of the tank moves freely.
Rinse the accessory and if necessary remove scale.
Remove the collector, make certain that it is empty, wait for 8
light re-
seconds and then fit it again.
Check that the cleaning tray is correctly pushed in.
The appliance will re-initialise automatically when power is
turned on and be ready for a new cycle.
The drip tray has overflowed: empty it and clean the cleaning
drawer.
Check that the drip tray is fitted correctly.
Do not remove the water tank before the end of the cycle.
Unplug the machine, remove the Claris cartridge, wait for 20
seconds and then turn it all back on.
If the fault persists, note the number which appears on the
display under the cup tray and contact the Rowenta
Consumer Service.
0845 602 1454 - UK
(01) 677 4003 - ROI
or consult our website - www.rowenta.co.uk
16
GB
Advertisement
Table of Contents
