Table of Contents
Advertisement
On Screen Messages
Check the following if a message appears on the display
when operating the Videoconferencing Terminal.
Message
Now obtaining an IP address via DHCP.
Configure the DNS address or use the IP
address to dial.
Access to the DNS server has failed. Check
the PPPoE DNS settings.
Cannot access the DNS server. Use the IP
address to dial.
Connection to the remote party via DNS
disabled. Dial using IP address.
The LAN cannot be used.
Communication via LAN is not available.
Check LAN connection.
LAN configuration error. Diffserve exceeds
the maximum value.
LAN configuration error. IP Precedence
exceeds the maximum value.
LAN configuration error. NAT Mode is set to
On. Check the NAT address.
LAN configuration error. An address
different from the NAT router is specified.
Check the NAT address.
LAN configuration error. PPPoE is set to
On. Check the PPPoE User Name and
Password.
LAN configuration error. Fixed IP for PPPoE
is set to ON. Check the PPPoE Fixed IP
Address.
LAN configuration error. (Gatekeeper error)
Check LAN configuration.
LAN configuration error. Gatekeeper Mode
is set to On. Enter the gatekeeper address.
LAN configuration error. Unauthorized NAT
address is specified. Check the NAT
address.
LAN configuration error. Unauthorized
network mask is set.
LAN configuration error. Connection is not
complete as the port number overlaps.
LAN configuration error. Connection is not
complete as an invalid port number is
specified.
Upgrading the LCD driver software. Please
wait.
PPPoE server admission fails. Dial again
after confirmation of the PPPoE settings.
Connection to the PPPoE server fails.
The system is connecting to a LAN via
PPPoE.
Meaning
The IP address of your system is assigned automatically by the DHCP server. If
the assignment is not successful, check the LAN settings.
Enter a DNS address or enter the IP address of the remote party.
Connection to the DNS server could not be established. Check the PPPoE DNS
server settings.
Domain name connection could not be established. Enter the IP address of the
remote party to connect.
Domain name connection could not be established. Enter the IP address of the
remote party to connect.
You cannot use the LAN connection for some reason. Check for correct cable
connections and verify that the LAN link LED indicators are lit. Also check the
network settings.
Check for correct cable connections and verify that the LAN link LED indicators are
lit.
Set the Diffserve item in the LAN Setup menu to a value between 0 and 64.
Set the IP Precedence item in the LAN Setup menu to a value between 0 and 7.
LAN connection via NAT is enabled. Check the NAT address.
Enter the correct NAT address from the LAN Setup menu.
The LAN connection is set to use PPPoE. A user name and password must be set.
Connection is set to use a fixed IP address for PPPoE. Enter the correct fixed IP
address for PPPoE.
Gatekeeper settings are not appropriate.
LAN connection via gatekeeper is enabled. Enter the gatekeeper address.
The entered NAT address is not valid. Enter the correct NAT address.
The subnet mask setting is invalid.
Connection to the remote party could not be established. Check whether there is a
conflict (overlap) between the "TCP port number" and "UDP port number" setting
in the LAN Setup menu.
Connection to the remote party could not be established. Check the "TCP port
number" and "UDP port number" setting in the LAN Setup menu.
The LCD software version is being upgraded. Do not turn power off until the
upgrade process is completed.
Connection to the PPPoE server could not be established. Check the various
PPPoE settings and dial again.
Check the DNS server settings.
The system is connecting to a LAN via PPPoE.
103
On Screen Messages
Advertisement
Table of Contents
