Table of Contents
Advertisement
1.4.2 Access Point Demo
This demo configures the Raspberry Pi and WF200 to work as a Wi-Fi access point which can accept stations. To start it, run:
sudo wfx_demo_ap
Then it is possible to connect to the Raspberry Pi using a Wi-Fi capable device and the following credentials:
• SSID: silabs-pi-demo
• Passphrase: default_password
On the device, use a browser to open http://silabs-pi-demo.wlan/.
1.5 Update SD Card
To download and install an SD card image, go to
1.6 Software Repositories
For development purposes, software can be found in the locations listed below:
• WF200 firmware is available in
• The Linux driver is available in
1.7 Documentation
Complete documentation for development with a Raspberry Pi is available here:
master/README.md
silabs.com | Building a more connected world.
https://github.com/SiliconLabs/wfx-linux-tools/blob/master/RELEASES.md
https://github.com/SiliconLabs/wfx-firmware
https://github.com/SiliconLabs/wfx-linux-driver
QSG166: WF200 Wi-Fi Development Kit Quick Start Guide
Getting Started with Raspberry Pi and Linux
https://github.com/SiliconLabs/wfx-linux-tools/blob/
Rev. 0.4 | 5
Advertisement
Table of Contents
Need help?
Do you have a question about the WF200 and is the answer not in the manual?
Questions and answers