Life Fitness PowerMill Integrity Series Operation Manual page 11

Plug in the PowerMill Climber
The Life Fitness PowerMill Climber has an internal power supply. Insert the power cord connector into the inlet connec-
tor on the PowerMill Climber and plug the other end of the cord into the wall outlet. Make sure that the power cord
shield is secured in place to prevent the power cord from being kicked out. Turn on the ON / OFF switch next to the
inlet connector and check that the console LED's light up. If not, check the inlet connector and the wall plug connec-
tions and make sure that the wall outlet has power.
Service Access Port
The two interchangeable type RJ45 networking ports (A) are located on the back of the display console. These network
ports, located behind the display console rear access door, allow for console and motor controller software updates.
10