Badger Meter FC-5000 User Manual page 43

Output Mode Option
OUTPUT SOURCE Parameter assignment (such as Flow Rate or Temperature)
LOW SETPOINT
HYSTERESIS LO
ALARM: LOW
SET DELAY
RELEASE DELAY
LATCHING
OUTPUT SOURCE Parameter assignment (such as Flow Rate or Temperature)
HIGH SETPOINT
HYSTERESIS HI
LOW SETPOINT
ALARM: RANGE
HYSTERESIS LO
SET DELAY
RELEASE DELAY
LATCHING
MANUAL OVERRIDE
April 2019
Description
Instructs the device to energize the relay if this value reached/
exceeded� This value is linked to the OUTPUT SOURCE and its unit
of measure (for example, Flow Rate in GPM)
Creates a window/zone above the LOW SETPOINT value where
the relay remains in an energized state
Time in seconds that will elapse before the relay energizes, if the
LOW SETPOINT value is reached/exceeded
Time in seconds that the relay will remain energized, if the
HYSTERESIS LO value is reached/exceeded
Leaves relay in an energized state until it is manually cleared on
the device, either through the keypad interface or through the
Digital I/O channels
Instructs the device to energize the relay if this value reached/
exceeded� This value is linked to the OUTPUT SOURCE and its unit
of measure (for example, Flow Rate in GPM)
Creates a window/zone below the HIGH SETPOINT value, where
the relay remains in an energized state
Instructs the device to energize the relay if this value reached/
exceeded� This value is linked to the OUTPUT SOURCE and its unit
of measure (for example, Flow Rate in GPM)
Creates a window/zone above the LOW SETPOINT value, where
the relay remains in an energized state
Time in seconds that will elapse before the relay energizes, if
either setpoint value is reached/exceeded
Time in seconds that the relay will remain energized, if either
hysteresis value is reached/exceeded
Leaves relay in an energized state until it is manually cleared on
the device, either through the keypad interface or through the
Digital I/O channels
Bypasses any programmed triggers to trigger the relay, which
will remain triggered until deactivated
Table 30: Relay settings
CTL-UM-01723-EN-03
Advanced Setup
Page 43