Edwards RV3 Instruction Manual page 2

Edwards Ltd,
Innovation Drive,
Burgess Hill,
West Sussex,
RH15 9TW, UK
The following product
Pump type
X
2 = RV3
3 = RV5
4 = RV8
5 = RV12
Is in conformity with the relevant requirements of European CE legislation:
2006/42/EC
2014/35/EU
2011/65/EU
Based on the relevant requirements of harmonised standards:
EN 1012-2:1996
+A1:2009
EN 60034-1:2010
EN 61010-1:2010 *
*1-phase pumps only
The product also complies with the following:
CSA-C22.2 No.77-2014#
CSA-C22.2 No.100-2014#
CSA-C22.2
No.61010-1-12
UL61010-1
3 rd Edition
#1-phase pumps only
This covers all product serial numbers from the date of this declaration onwards.
Mr Ian Keech
Vice President Engineering, High Vacuum Division
This product has been manufactured under a quality management system certified to ISO 9001:2015.
This declaration is based on the requirements of EN ISO 17050-1 and the relevant directives.
Declaration of Conformity
A65X – YY – ZZZ
Variant Motor description
YY ZZZ
01 to 99 903 = 220-240V, 50/60Hz, Single phase
904 = 100/200V, 50/60Hz, Single phase
905 = 200-230/380-460V, 50/60Hz, Three phase
906 = 110-115/120, 50/60Hz, Single phase
925 = 200-230/380-460V, 50/60Hz, Three phase set to low voltage
Machinery directive
Low voltage directive (LVD) as applicable to electrical sub-assemblies
Restriction of certain hazardous substances (RoHS) directive
Compressors and vacuum pumps. Safety requirements. Vacuum pumps
Rotating electrical machines. Rating and performance
Safety requirements for electrical equipment for measurement, control and laboratory use.
General requirements
The pumps comply with EN 61010-1 when installed in accordance with the instruction manual supplied
with the pumps.
Motors with inherent overheating protection
Motors and generators
Safety requirements for electrical equipment for measurement, control and
laboratory use – Part 1: General requirements
Safety requirements for electrical equipment for measurement, control and
laboratory use – Part 1: General requirements
Canadian Standards Authority and Underwriters Laboratory
19.03.2018, Burgess Hill
Date and Place