Ink Absorber Box - Brother MFC-J3520 Service Manual

9.3

Ink Absorber Box

(1) Remove the Ink absorber box.
(2) Pull out the Air vent tube and Drain tube from the Ink absorber box.
Note: Pinch the ends of the Air vent tube and Drain tube with the clips in order to
prevent drained ink from leaking and the machine from getting stained with
leaked ink.
Ink absorber
box
Drain tube
Air vent tube
Assembling Note:
- It is not necessary to trim the ends of the Drain tube and Air vent tube when
reconnecting those tubes to the Ink absorber box.
- Take care not to connect the Drain tube or Air vent tube to the Ink absorber box at an
angle. Tubes connected at an angle come off easily, resulting in ink leakage. After
connection, check that there is no ink leakage.
- If you replace the Ink absorber box (without replacing the main PCB ASSY), reset the
purge count, using the procedure given in
flushing counts."
It is also recommended that the flushing box be replaced and the flushing count be
reset as necessary since the flushing count may approach the upper limit.
Correct
Fig. 3-24
Drain tube
Do not connect the Drain
tube at an angle.
Connect the tube all the way seated.
Fig. 3-25
3-41
Chapter 4, Section 1.14 "Reset purge and
Wrong
Ink absorber
box
Confidential