Cleaning; Precautions; Cleaning Guidelines For The Infinea X Mini - Infinite Peripherals INFINEA X mini User Manual

CLEANING

Precautions

The Infinea X mini is certified to meet IP54 Ingress Protection Marking per IEC 60529. Per the IP54
rating, the Infinea X Mini is protected against interference with normal operation of the Infinea X Mini
sled caused by dust and splashing liquids. At no time should the Infinea X Mini's sled be completely
immersed in liquid. Total submersion of the device may allow liquid to enter the unit and impair its
normal function. Immersion will also void the Infinea X Mini warranty.
The Infinea X mini is molded using medical–grade materials that are formulated with an anti-microbial
additive. Please review the specifications for Silver Seal™ to ensure that the specifications are sufficient
and appropriate for the intended use and environment. The end user should determine an appropriate
cleaning procedure that complies with any facility and/or industry-specific cleaning requirements. The
following information is a general cleaning guideline that should be followed to ensure the Infinea X
Mini maintains its normal operation.

CLEANING GUIDELINES FOR THE INFINEA X mini

1. Do NOT autoclave, machine wash, pressure-sterilize or gas-sterilize the Infinea X mini.
2. Do NOT soak or immerse in any liquid.
3. Clean the Infinea X mini only when the battery module is properly installed and locked into the
unit. This ensures proper sealing of the Infinea X mini prior to introducing any solutions and/or
wipes used during the cleaning process.
4. Apply cleaning solutions with a soft lint-free cloth. If the solution comes in the form of a wipe,
ensure the wipe is lint-free and will not scratch the plastic surfaces (especially the scan window).
Excessive solution that resides in any of the waterproof membrane or gasket areas can seep into
the devices and cause damage to the internal components.
5. Do not touch, press or rub the display and/or covers with abrasive cleaning compounds,
instruments, brushes, rough surface material or bring the display and/or covers into contact with
products that could potentially scratch the display or covers.
6. To clean the Infinea X Mini screw areas, use a soft-bristled brush with approved cleaning
solutions. Focus cleaning in the screw areas, ensuring that the brush is not used in areas that
contain seals or gaskets.
7. Do not use ammonia based, petroleum-based or acetone cleaning solutions to clean the Infinea
X mini. Also avoid harsh solvents.
8. Use the following cleaning solutions only to clean the Infinea X mini exterior surfaces:
• Clorox® Bleach (10%)
• Isopropyl Alcohol Wipes (70%)
Infinea® X Mini User Manual
UM-00013 Rev B
Page 28 of 31