Siemens FM 458-1 DP Manual page 73

SIMOLINK drive coupling
I/O
TAD Hardware address SLB (name of the SLB module), which can be
configured in HWConfig
FSL Address of the first slave to which setpoint XO0 should be set, value
range 1 . . . 200
(initialization connection)
Number of slaves to which the setpoint should be sent, value range
NSL
1. . . 8
(initialization connection)
Axis cycle length
ACL
Upper integrator limit value
Channel number for setpoint 2, value range 0 . . . 7
CTV
(initialization connection)
CSV Number of the channel on which the setpoint is sent,
Value range 0 . . . 7
(initialization connection)
XSA Common setpoint XS of the main angle/position for all NSL slaves
XO0 Setpoint offset XO for slaves 1 to 8,
A maximum of 8 setpoint offsets can be sent.
to
XO7
SEQ Sequence number
Number of the block in the SIMOLINK block sequence
This value provides information as to whether the block was correctly
initialized.
Error status of the block
YF
YF=0 no error, YF > 0 refer to coded error output @SL
QF Group error bit
QF=0 no error, QF=1 for error (if YF≠0)
Configuringdata
5-16
Computation time [µs]
Can be inserted online
Can be configured in
Executed in
Special features
FM 458-1 DP 39,6
No
Interrupt tasks
Cyclic tasks
Initialization mode
Normal mode
-
Function Blocks - FM 458-1 DP
(default: 1)
(default: 1)
(default: 0)
(default: 0)
(default: 0)
(default: 0)
(default: 0)
(default: 0)
(default: 0)
(default: 0)
Edition 12.2004