Siemens FM 458-1 DP Manual page 67

SIMOLINK drive coupling
I/O
TAD SLB hardware address (name of the SLB module), which can be
configured in HWConfig
Address of the first slave from which the actual value YA0 should
FSL
be received, value range 1 . . . 200
(initialization connection)
No. of slaves, from which actual values are to be received,
NSL
value range 1. . . 8
(initialization connection)
Channel number on which the actual value is received,
CSV
value range 0 . . . 7
(initialization connection)
Enable cross-data transfer
QV
This is used, if data is to be sent to a slave in the same cycle which
is physically located in front in the SIMOLINK ring (e.g. from slave 4
to slave 1).
Actual value YA from slaves 1 to 8
YA0 to
A maximum of 8 actual values can be received.
YA7
SEQ Sequence number
Number of the block in the SIMOLINK block sequence
The value supplies info as to whether the block was correctly
initialized.
YF Error status of the block
YF=0 no error, YF > 0 refer to coded error output @SL
QF Group error bit
QF=0 no error, QF=1 for error (if YF≠0)
Configuringdata
5-10
I
Computation time [µs]
Can be inserted online
Can be configured in
Executed in
Special features
FM 458-1 DP 34,7
No
Interrupt tasks
Cyclic tasks
Initialization mode
Normal mode
-
Function Blocks - FM 458-1 DP
(default: 1)
(default: 1)
(default: 0)
(default: 0)
(default: 0)
(default: 0)
(default: 0)
(default: 0)
Edition 12.2004