Progres AGRONIC 4000 Instruction Manual page 38

38
General : 1
Out of general service (Y/N) : NO
Before the out of service is carried out, the con-
firmation will be asked, yet once it is done the values
of the irrigation that is taking place are cancelled from
the program which is being carried out or from all of
them, at the general. It can be of use when the irriga-
tion of all the programs that are taking place it wants
to be cancelled. This can be done by entering for a
while at the general out of service and leaving after-
wards.
The "STOP" can be done from here or through
the key. The functions and the unit outputs are
stopped then, being reactivated at the same point
when the Stop ends. While it is stopped, the programs
continue starting but the leave at stand by, besides
this, the keyboard beeper emits an advice beep every
ten seconds.
At the "Programs" manual action, an irrigation
programming can be started at any sub-program; on
the other hand, if the program has already started it
will be possible to finish it.
The number of program and sub-program will be
asked at first, and then, the confirmation in order to
stop or finish.
Program number : 05-01
Start (Y/N) : YES
The "Malfunctions" sector is used to finish, once
repaired and according to the user, any anomaly. At
most of the cases the irrigation is restarted at the
same point it stopped.
At "Filters" a cleaning or backflushing can be
started or stopped.
When entering at the option "6" "Outputs" of the
menu, the following screen appears, where it is possi-
ble to directly activate the relay outputs. Care has to
be extremely taken yet no kind of control exists and
damages can be caused to the installation (securities
are no taken into account). This function is only of
use, for the installer, when setting all the elements.
To exit the screen, the 8 possible outputs have to
be at 0, it means, deactivated.
At the "outputs connection" [4.3.4.] there is a
chart with the relays situation. We recommend con-
sulting it.
Program : 2
11. CLOCK
The CLOCK function will be used to set on the in-
ternal clock of the Agrónic 4000. To do so, press the
"FUN" key, choose the function by its number (6) and
then press "Enter".
Programs : 1 Readings: 2
Parameters: 4 Manual : 5
Enter the day of the week, day of the month, the
month, the last two digits of the year, the hour, the
minutes and the seconds according to this order.
When pressing "Enter" at the seconds the clock is up
dated.
Wednesday 17/08/02 20:06.33
Erasure : 3
Clock : 6