Miscellaneous Parameters - Progres AGRONIC 4000 Instruction Manual

It is necessary to install the internal modem in the
Agrónic 4000 in order to communicate with the ex-
pansion modules by two wires of 24 volts of alternate
power.
6.8.9. Communication with Microisis
This indicates if communication with the MicroIsis
is to be activated or not.
Communication with Microisis :
Activate : 2
Communication with MicroIsis :
Communicate to Microisis 1 ? Y.
Communication with the MicroIsis is always
through port 2 (RS485). In this case, the RS485 port
only it may be shared with the µMetos.
6.8.10. Communication with µMetos
This allows activation or deactivation of commu-
nication with uMetos. Communication is always
through port 2 (RS485).

6.9. MISCELLANEOUS PARAMETERS

In order to adjust the sonorous level of the key-
board "bip", 1 has to be entered for a low level and 9
for the highest one. It remains disabled at 0.
Keyboard sonorous level: 2
The Agrónic 4000 allows access codes in order to
limit the functions and/or parameters use. The codes
are formed by four digits and can be modified at this
section. To do so, the correct code has to be entered
modifying it afterwards if necessary. When it shows
the value " - - - - " it means there is a code assigned
but there is no code with "0000".
In order to cancel the question, assign code 0 at
functions or parameters.
Functions access codes : - - - -
Parameters access code : 0000
In order to guarantee the correct use of the SMS
messages from a mobile phone it is necessary to en-
ter here the access code which will contain a message
later on. Further details at section [6.8.3].
SMS Messages access code : 1234
If due to practical needs some programs or sec-
tors want to be copied, it can be done from this sec-
tion.
Copy programs (Y/N) : YES
Copy program 00 from 00 to 00
Copy sectors (Y/N) : YES
Copy sector 00 from 00 to 00
29