Progres AGRONIC 4000 Instruction Manual page 27

6.8.3. Messages sending from a GSM tele-
phone
When the Agrónic 4000 has the "SMS messages"
option activated and is connected to a GSM modem,
orders can be sent from a digital mobile telephone.
The format the SMS message to be sent to the Agrónic 4000 must have, is the next:
o Unit series number (4 digits)
o Blank space "Esp"
o Access code (4 digits: entered by the user at miscellaneous parameters)
o Blank space
o Operation code "OP1, 2 .."(separated by a blank space between them)
S S S S
Series number
Operation code
Activate program
Activate program with an
irrigation factor for this
activation
Stop the irrigation of a
program
Modify the manual factor
of one or more programs
Switch on or off the STOP
Start a filter cleaning
Value for virtual inputs
Deactivate any alarm,
Stop or out of order.
Request for immediate
"Send inform"
Cancel all the text SMS
messages
Examples of messages =
"0001 1234 AP 01 01"
"0001 1234 AP 05 01 –25"
"0001 1234 MF 01 +12 +18 +05"
"0001 1234 ST YES"
"0001 1234 SM"
Once the message has been received and exe-
cuted by the Agrónic 4000, it will send a message with
the following text "Message received. Order executed"
to the phone which sent the message (except with SM
code).
The value of sensor virtual inputs has to be en-
tered in the same format that has been configured at
the input. For example, at the most common case of
X X X
Esp. Access code
OP1 OP2 OP3 OP4 OP5 OP6 OP7 OP8 OP9
AP np ns
AP np ns
SP np
±00
MF np
(np)
ST cd
FC gn
xxxx
IV se
(se)
AL
SI
SM
These orders can be to start, stop or modify the
manual factor of the programs, to switch on or off the
STOP, to do a filter cleaning, to give an Analog value,
to deactivate any kind of alarm and to send an imme-
diate report.
X Z Z
Spa OP1 Spa.
±00
±00 ±00 ±00 ±00
(np (np (np (np
+1) +2) +3) +4)
xxxx xxxx Xxxx Xxxx
(se (se (se (se
+1) +2) +3) +4)
Start the program 1 irrigation at the sub-program 1.
Start pro. 5 at the sub-pro. 1 reducing the irrigation a 25%.
Modify the manual factors of programs 1 to 3.
Set the unit at STOP.
Cancel the text messages.
the evapotranspiration, it is "0.00".
The "SM" code is used to cancel the text mes-
sages, of utility for example, when a message of
anomaly by damaged sensor is constantly repeated.
In order to send messages again, a number has to be
discharged at "serial port" by entering at "SMS mes-
sages" [6.8.2] in communications parameters.
Z Z Z .. .
OP2 Spa. OP3
OP
Nomenclature
10
np: program
ns: sub-program.
np: program
ns: sub-program
±00 : factor
np: program
±00 ±00 ±00
np: program
(np (np (np
±00 : factor
+5) +6) +7)
cd= YES, NO
gn: group number
xxxx xxxx Xxxx
se: sensor number
(se (se (se
1 to 8
+5) +6) +7)
27
....