Siemens SINUMERIK 802S Start-Up page 144

Technical Appendix
6.3 PLC user program for turning (UPGMTURN)
[4] O 0.7
[5] O 1.7
[6] O 0.7
[7] O 1.7
[8] K7
[9]
[10]
[11]
Input valid :
Output valid :
Input / output 0-active:
MCP customer key valid:
Rotation monitoring active: 0 - Rotation monitoring function is not used
after referencing the axis. The UPGMTURN sets the Rotation Monitoring interface signal
(390x5000.0) (see "Technical Manual: Rotation Monitoring of Step-Switching Motor with
BERO")
Machine configuration: (bit0) key assignment X axis to MCP
6-144
O 0.6 O 0.5 O 0.4
O 1.6 O 1.5 O 1.4
O 0.6 O 0.5 O 0.4
O 1.6 O 1.5 O 1.4
MCP customer key valid
K6 K5
MCP customer key valid
Rotation monitoring active
Machine configuration
Override
active
0 - demask input not used
1 - input is used
0 - demask output not used
1 - output is used
0 - All signals use positive logic as standard, i.e.
logic 1-active (24V).
1 - When connecting to systems with negative
logic, i.e. logic 0-active (0V).
0 - Demask MCP customer keys not used
1 - MCP customer key is used
1 - Rotation monitoring is activated for the relevant axis (X, Z)
0 – tool behind turning center
1 – tool ahead of turning center
O 0.3 O 0.2
Output valid
O 1.3 O 1.2
Output 0-active
O 0.3 O 0.2
Output 0-active
O 1.3 O 1.2
K4 K3 K2
O 0.1 O 0.0
O 1.1 O 1.0
O 0.1 O 0.0
O 1.1 O 1.0
K1 K0
K9 K8
Z axis X axis
Key
assignment
X axis
SINUMERIK 802S
6FC5 597–2AA00–0BP2 (01.02)