Changing The Service Level Password - Data Aire Mini dap4 Installation, Operation & Maintenance Manual

To enter the Menu and Sub-Menu screens, press the MENU key on the display panel. A password will be requested.
The password is a four digit entry (including 0). Units are shipped from the factory with the password requirement
bypassed to accommodate start-up and set-up.
The display screen will have the following message:
The Service Level Password setting from the factory is: 0000
The cursor will be flashing at the top of the screen. Press the ENTER key to move the cursor to the first field. Press
the UP or DOWN keys to increase or decrease the value. Once the value is entered, press the ENTER key to move
to the next input. Increase or decrease the value by pressing the UP or DOWN keys. Once the desired value is shown,
press the ENTER key to move to the next field.
Once the correct password is entered and accepted, the Menus will display on the screen. Only those Menus allowed
through the Service Password will be available. Use the UP or DOWN keys to scroll through the available Menus.
Note: Factory Level Menus are for configuring the unit. The Mini dap4 controller is used for a variety of equipment
types. The controller is based on the unit type, unit components and options. Under normal circumstances these
menus should not be changed. If they need to be changed, please consult with Data Aire engineering or service per-
sonnel before proceeding.
2.2.1

Changing the Service Level Password

The Service Level password can be changed while the service level menu is active.
▼ After entering the Service password press Menu key again then press Down key, the screen will display the follow-
ing message:
▼ Press the ENTER key. The cursor will highlight the first input. Change the input by pressing the UP or DOWN key.
Once the selected number is displayed, press the ENTER key to move to the next input. Repeat the same steps for
each input.
After the last input has been entered the new password is stored. Press the MENU key to return to Main Menu.
9 • Mini dap4 User Manual
Security Access
Insert Service/Factory
level password: 0000
Service Security
Change service level
password (PWI): 0000