Configuration
4.10 Serial interface > Advanced options
4.9.3
Web server access
Access to the Web server
You can activate access to the Web server of the TIM via HTTP/HTTPS for each individual
Ethernet interface.
As default access is disabled. Refer to the explanations in section Security
recommendations (Page 51).
You enable the Web server and make further settings in the parameter group "Web server",
see section Web server (Page 79). There you can also enable or disable access.
For access to the Web server you need to enable access on the Ethernet interface ("Access
to the Web server") and enable the Web server itself "Web server".
4.10
Serial interface > Advanced options
4.10.1
MSC settings
The parameter group becomes visible if you use the serial interface as an Ethernet interface
(WAN type = IP-based).
For a description of the parameters, see section MSC protocol settings (Page 67).
4.10.2
Dedicated line
Settings dedicated line
Only the configurable parameters are explained.
Settings serial interface
● Interface standard
Standard of the serial interface: RS232 / RS485
Select the following value:
– RS232
– RS485
● RS-485 termination
Enable the option when connecting a terminating resistor for the RS-485 bus when a star-
shaped network is connected.
72
When a modem with an RS-232 interface is connected to the interface of the TIM
When a modem with an RS-485 interface is connected
With parallel connection of several modems to the interface of the TIM (star-shaped
network)
Operating Instructions, 02/2018, C79000-G8976-C468-02
TIM 1531 IRC