Step 7 V5 Configuration Of The Proxy; Configuration In Step 7 V5; C.1 Configuration In Step 7 V5 - Siemens TIM 1531 IRC Operating Instructions Manual

STEP 7 V5 configuration of the proxy

Note
Use of the TIM
The information on configuration in STEP 7 V5 applies only in situations where you want to
use the TIM as a communication module with the functions of a TIM 4R-IE in existing
SINAUT ST7 systems.
See also
Expansion of SINAUT projects (Page 28)
C.1

Configuration in STEP 7 V5

Configuration of a proxy in STEP 7 V5
1. Open the STEP 7 V5 project that you wish to expand with S7-1200/1500 modules.
2. Create an S7-300 station with CPU and the new necessary networks, if applicable.
The CPU only serves as placeholder to receive the SINAUT subscriber number.
3. Insert the "proxy" in the station.
4. Perform the configuration in STEP 7.
Deviations from the normal configuration are described below.
5. Perform the configuration in the connection configuration of the SINAUT engineering
software.
6. Export the configuration data of the proxy via the SINAUT diagnostics and service tool.
For information on this, refer to section Exporting configuration data (Page 316).
The data exported from STEP 7 V5 is adopted later in the STEP 7 Basic project for the
S7-1200/1500 communication module.
TIM 1531 IRC
Operating Instructions, 02/2018, C79000-G8976-C468-02
C
313