Preparation And Operation; Connecting Up The Module - Weinmann Prisma2Cloud WM 100 MW Instructions For Use Manual

4 Preparation and operation

4 Preparation and operation

4.1 Connecting up the module

Result
34 EN prisma2CLOUD
The module can be connected up to all WM 100 TD therapy
devices and other modules.
1. Place the therapy device on a level surface (e.g., a table).
2. Switch on the therapy device (see instructions for use of the
therapy device).
You can also connect the module when the therapy device is
switched off. Then switch on the therapy device.
3. Open the system interface cover on the right side of the
therapy device.
4. Keep the unlocking button on the module depressed.
5. Slide the module's locking hooks into the mounting holes on
the therapy device.
6. Push the module against the device until it clicks into place.
The symbol appears on the therapy device's display.
Module is connected.