Chrysler Concorde 2004 Service Manual page 2822

23 - 90 SEATS
SEAT SIDE SHIELD
REMOVAL
REMOVAL - NON AIRBAG
(1) Remove front seat from vehicle (Refer to 23 -
BODY/SEATS/FRONT SEAT - REMOVAL).
(2) Remove screws attaching seat cushion side
shield to the bottom and side of seat cushion (Fig. 26)
and (Fig. 27).
(3) Remove shield from seat
(4) Disconnect switch wire connectors, if equipped.
(5) Remove seat switches, if equipped.
Fig. 26 BOTTOM VIEW OF SIDE SHIELD AND
TIGHTENING SEQUENCE
Fig. 27 SIDE VIEW OF SIDE SHIELD
1 - SIDESHIELD FASTENERS
REMOVAL - AIRBAG EQUIPPED
WARNING: DISCONNECT AND ISOLATE THE NEGA-
TIVE BATTERY CABLE
BEFORE BEGINNING ANY FRONT SEAT REMOVAL
OR INSTALLATION PROCEDURE. THIS WILL DIS-
ABLE THE AIRBAG SYSTEM. FAILURE TO DISCON-
NECT THE BATTERY
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
REMOTE TERMINAL
COULD RESULT
WARNING: IF EQUIPPED WITH AIRBAG, AFTER
THE NEGATIVE CABLE IS DISCONNECTED WAIT
FOR 2 MINUTES BEFORE DISCONNECTING OR
REMOVING ANY AIRBAG SYSTEM COMPONENTS.
(1) Disconnect and isolate the remote negative bat-
tery cable.
(2) Remove seat from vehicle. Refer to the proce-
dure in this group.
(3) Remove screws attaching seat cushion side
shield to the bottom and side of seat cushion (Fig. 26)
and (Fig. 27).
(4) Remove shield from seat
(5) Disconnect switch wire connectors, if equipped.
(6) Remove seat switches, if equipped.
INSTALLATION
INSTALLATION - NON AIRBAG
(1) Transfer seat switches, if equipped.
(2) Connect switch wire connectors to cushion side
shield, if equipped.
(3) Place shield in position on seat cushion.
(4) Install screws attaching seat cushion side
shield. Tighten screws in sequence, refer to (Fig. 26).
(5) Install front seat (Refer to 23 - BODY/SEATS/
FRONT SEAT - INSTALLATION).
INSTALLATION - AIRBAG EQUIPPED
(1) Transfer seat switches, if equipped.
(2) Connect switch wire connectors to cushion side
shield, if equipped.
(3) Place shield in position on seat cushion.
(4) Install screws attaching seat cushion side
shield. Tighten screws in sequence, refer to (Fig. 26).
(5) Install seat. Tighten front screws to 61 N·m (45
ft. lbs.) and the rear screws to 61 N·m (45 ft. lbs.)
torque.
(6) Connect the remote negative battery cable.
LUMBAR SUPPORT
REMOVAL
The front seat lumbar support is not service sepa-
rately. The front seat back frame will need to be
replaced.
IN
LH