Chrysler Concorde 2004 Service Manual page 2583

LH
42LE AUTOMATIC TRANSAXLE (Continued)
(c) Install input clutch assembly. Ensure the
input clutch assembly is completely seated by view-
ing position through input speed sensor hole (Fig.
128). If view through input speed sensor hole
is not as shown in (Fig. 128), the input
clutches assembly is not seated properly.
Fig. 128 View Through Turbine Speed Sensor Hole
1 - TRANSAXLE COOLER LINE
2 - TURBINE SPEED SENSOR HOLE
(d) Remove the oil pump o-ring (Fig. 129) and
install oil pump and gasket to transaxle. Use
screw-in dowels or phillips-head screwdrivers
to align pump to case. Be sure to reinstall
O-ring on oil pump after selecting the proper
No. 4 thrust plate.
(e) Measure the input shaft end play with the
transaxle in the vertical position. This will ensure
that the measurement will be accurate.
(f) Set up and measure endplay using End Play
Set 8266 and Dial Indicator Set C3339 as shown in
(Fig. 130).
Fig. 129 Remove Oil Pump O-Ring
1 - OIL PUMP ASSEMBLY
2 - O-RING
(g) Measure input shaft end play. Input shaft
end play must be .005 to .025 inch. For exam-
ple, if end play reading is 0.055 inch, select No. 4
Thrust Plate which is 0.071 to 0.074 thick. This
should provide an input shaft end play reading of
0.020 inch, which is within specifications.
(h) See chart to select the proper No. 4 thrust plate.
NO. 4 THRUST PLATE CHART
PART NUMBER
3836237AB
4431666AB
3836238AB
4431667AB
3836239AB
4431668AB
3836240AB
4431669AB
3836241AB
4446670AB
4446671AB
(i) Remove oil pump, gasket, and input clutch
assembly to gain access to and install proper #4
thrust plate.
CAUTION: If view through input speed sensor hole
is not as shown in (Fig. 128), the input clutches
assembly is not seated properly.
Fig. 130 Measure Input Shaft End Play Using Tool
8266—Typical
1 - TOOL 8266–8
2 - TOOL 8266–2
3 - TOOL C-3339
TRANSAXLE 21 - 41
THICKNESS
1.73mm (0.068 in.)
1.80mm (0.071 in.)
1.96mm (0.077 in.)
2.03mm (0.080 in.)
2.16mm (0.085 in.)
2.24mm (0.088 in.)
2.39mm (0.094 in.)
2.46mm (0.097 in.)
2.62mm (0.103 in.)
2.67mm (0.105 in.)
2.90mm (0.114 in.)