Chrysler Concorde 2004 Service Manual page 2623

LH
FINAL DRIVE (Continued)
(20) Remove transfer shaft preload shim (Fig.
183). If transfer shaft bearings are to be reused, the
original shim must also be reused.
Fig. 183 Preload Shim Removal
1 - TRANSFER SHAFT PRELOAD SHIM
2 - TRANSFER SHAFT
(21) Remove transfer shaft assembly from case
(Fig. 184).
Fig. 184 Remove Transfer Shaft Assembly From
1 - TRANSFER SHAFT
Case
CAUTION: If the transfer shaft is removed from the
transaxle case for any reason, both seals must be
replaced.
(22) Remove transfer shaft seals using special tool
6310 and foot 6310-9 (Fig. 185). Do not reuse old
seals. The seals will be pulled out the rear of the
case.
Fig. 185 Transfer Shaft Seal Remover
1 - SPECIAL TOOL 6310
(23) Remove the front transfer shaft bearing cup
using special tool 6495 and handle C-4171 (Fig. 186).
Use a press with special tools to remove cup.
Fig. 186 Front Transfer Shaft Cup Removal
1 - SPECIAL TOOL C-4171
2 - SPECIAL TOOL 6495
TRANSAXLE 21 - 81