Chrysler Concorde 2004 Service Manual page 2755

LH
LOCK CYLINDER (Continued)
INSTALLATION
(1) Push lock cylinder into socket on door handle.
(2) Insert link into clip on lock cylinder.
(3) Engage clip to fasten lock link to lock cylinder.
(4) Verify lock operation.
(5) Install watershield.
(6) Install door trim panel. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - INSTALLATION)
SIDE VIEW MIRROR FLAG
REMOVAL
(1) Pull cover, release clips and remove (Fig. 13).
(2) Remove the bolts and remove the bracket, if
necessary.
Fig. 13 MIRROR FLAG COVER W/O SPEAKER
1 - FRONT DOOR COVER W/O SPEAKER
2 - FRONT DOOR BRACKET
INSTALLATION
(1) If previously removed, install the door bracket
and bolts.
(2) Install the cover and engage the clips (Fig. 13).
SIDE VIEW MIRROR FLAG
REMOVAL - WITH SPEAKER
(1) Open the front door.
(2) Remove fasteners attaching the front door flag
enclosure cover to the door. Remove speaker from
cover, if necessary (Fig. 14).
(3) Remove fasteners attaching the front door flag
enclosure plate to front door, if necessary.
Fig. 14 MIRROR FLAG ENCLOSURE
1 - FRONT DOOR ENCLOSURE PLATE
2 - FRONT DOOR WITH SPEAKER COVER
INSTALLATION - WITH SPEAKER
(1) Install fasteners attaching the front door flag
enclosure plate to front door.
(2) Install speaker to front door flag enclosure
cover, if necessary.
(3) Install fasteners attaching the front door flag
enclosure cover to the door.
TRIM PANEL
REMOVAL
CAUTION: Do not pry on door trim panel, damage
to trim panel will result.
(1) Remove speaker flag and housing.
(2) Remove speaker grille by inserting trim tool at
the rear of the grille and disengaging tabs holding to
trim panel. Remove grille (Fig. 15).
(3) Open trim plug from the pull cup and remote
bezel by inserting a small flat blade tool into the
notch and lifting up.
(4) Remove three screws from bottom of door.
(5) Remove screw in pull cup.
(6) Remove screw in remote bezel.
(7) Remove two screws in the instrument panel
interface area.
DOOR - FRONT 23 - 23