Chrysler Concorde 2004 Service Manual page 2813

LH
HEADREST SLEEVE - AIRBAG
EQUIPPED
REMOVAL - AIRBAG EQUIPPED
WARNING: DISCONNECT AND ISOLATE THE NEGA-
TIVE BATTERY CABLE
BEFORE BEGINNING ANY FRONT SEAT REMOVAL
OR INSTALLATION PROCEDURE. THIS WILL DIS-
ABLE THE AIRBAG SYSTEM. FAILURE TO DISCON-
NECT THE BATTERY
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
WARNING: ONCE THE NEGATIVE CABLE IS DIS-
CONNECTED WAIT FOR 2 MINUTES BEFORE
REMOVING ANY AIRBAG SYSTEM COMPONENTS.
(1) Disconnect the remote negative battery cable.
(2) Remove the head restraint from the seat back
(Refer to 23 - BODY/SEATS/HEADREST - REMOVAL).
(3) Remove the back panel from the seat back.
(4) Disengage upper J-strap from seat back trim
cover. (Fig. 5)
(5) Working through the rear of seat back, depress
the two head restraint guide sleeve retaining tabs
and pull guide straight up and out of the seat back.
Fig. 5 TRIM COVER J-STRAP POSITION &
ORIENTATION
1 - TRIM COVER J-STRAPS
2 - SEAT HEATER WIRE HARNESS
3 - SEAT AIRBAG WIRE HARNESS
REMOTE TERMINAL
COULD RESULT
INSTALLATION - AIRBAG EQUIPPED
NOTE: The head restraint guide sleeve equipped
with height adjustment button is always installed on
the left side of the seat back.
(1) Install guides in seat back making sure they
are snapped in place.
(2) Install J-strap retainer.
(3) Install the back panel on the seat back.
(4) Install the head restraint on the seat back
IN
(Refer to 23 - BODY/SEATS/HEADREST - INSTAL-
LATION).
(5) Connect the remote negative battery cable.
FRONT SEAT
REMOVAL
REMOVAL
(1) Position seat far enough forward to gain access
to rear mount bolts on floor.
(2) Remove bolts attaching rear of seat track to
floor (Fig. 6).
(3) Move seat rearward.
(4) Remove bolts attaching front of the seat track
to floor kick up.
(5) Disconnect front seat wire harness connector
from body harness connector, if equipped.
(6) Remove front seat from vehicle.
Fig. 6 FRONT SEAT REMOVAL
1 - FRONT BOLTS
2 - REAR BOLTS
SEATS 23 - 81