Chrysler Concorde 2004 Service Manual page 2818

23 - 86 SEATS
FRONT SEAT BACK COVER (Continued)
Fig. 15 NEGATIVE BATTERY CABLE REMOTE
TERMINAL
1 - RIGHT STRUT TOWER
2 - AIR CLEANER INLET TUBE
3 - REMOTE TERMINAL
Fig. 16 SEAT BACK J-STRAP POSITION &
ORIENTATION
1 - TRIM COVER J-STRAPS
2 - SEAT HEATER WIRE HARNESS
3 - SEAT AIRBAG WIRE HARNESS
(8) Install front seat back (Refer to 23 - BODY/
SEATS/FRONT SEAT BACK - INSTALLATION).
(9) Install head restraint (Refer to 23 - BODY/
SEATS/ARMREST - FRONT - INSTALLATION).
(10) Check seat back operation.
Fig. 17 RECLINER PIVOT BOLT
1 - RECLINER BOLT
Fig. 18 AIRBAG MODULE INSTALLATION
1 - Airbag Module Nylon Sleeve
2 - Airbag Module
3 - Seat Back Frame
INSTALLATION - AIRBAG EQUIPPED
(1) Position cover on seat back foam.
(2) Carefully roll cover down to the area that hog
rings are to be installed. Install hog rings.
(3) Roll cover downward, fastening velcro as you
go.
(4) Position seat back foam and cover on frame.
CAUTION: Seat Airbag Module Must Be Installed IN
Nylon Sleeve. Failure To Do So Will Adversely
Affect Function Of Airbag System.
LH