Removal; Installation; Speed Sensor - Output Description - Chrysler Concorde 2004 Service Manual

21 - 144 TRANSAXLE
SPEED SENSOR - INPUT (Continued)

REMOVAL

(1) Disconnect the input speed sensor connector
(Fig. 385).
Fig. 385 Speed Sensor/Connector Location
1 - MANUAL SHIFT LEVER
2 - OUTPUT SPEED SENSOR
3 - LONG STUB SHAFT
4 - INPUT SPEED SENSOR
(2) Unscrew and remove the input speed sensor.
(3) Inpsect the speed sensor o-ring and replace if
necessary (Fig. 386).
Fig. 386 O-Ring Location
1 - INPUT SPEED SENSOR
2 - O-RING

INSTALLATION

(1) Verify o-ring is installed into position (Fig.
386).
(2) Install and tighten input speed sensor to 27
N·m (20 ft. lbs.) torque.
(3) Connect speed sensor connector (Fig. 385).
(4) Connect battery negative cable.
SPEED SENSOR - OUTPUT
DESCRIPTION
The Output Speed Sensor is a two-wire magnetic
pickup device that generates an AC voltage signal as
rotation occurs. It is threaded into the transaxle case
(Fig. 387), sealed with an o-ring (Fig. 388), and is
considered a primary input to the Powertrain Control
Module (PCM).
Fig. 387 Speed Sensor Location
1 - INPUT SPEED SENSOR
2 - OUTPUT SPEED SENSOR
3 - IDENTIFICATION TAG
Fig. 388 O-Ring Location
1 - OUTPUT SPEED SENSOR
2 - O-RING
LH