Chrysler Concorde 2004 Service Manual page 2656

21 - 114 TRANSAXLE
INPUT CLUTCH ASSEMBLY (Continued)
(4) Install the OD/Reverse piston assembly to the
input clutch retainer as shown in (Fig. 294).
Fig. 294 Install OD/Reverse Piston
1 - PUSH DOWN TO INSTALL OVERDRIVE/REVERSE PISTON
2 - INPUT CLUTCHES RETAINER
(5) Install the input hub/shaft assembly to the
OD/Reverse piston/clutch retainer assembly (Fig.
295).
Fig. 295 Install Input Shaft Hub Assembly
1 - PUSH DOWN TO INSTALL INPUT SHAFT HUB ASSEMBLY
(ROTATE TO ALIGN SPLINES)
2 - OD/REV. PISTON
(6) Install input hub tapered snap ring (Fig. 296).
Make sure snap ring is fully seated.
Fig. 296 Install Input Hub Tapered Snap Ring
1 - INPUT SHAFT
2 - INPUT HUB SNAP RING (TAPERED SIDE UP WITH TABS IN
CAVITY)
3 - SNAP RING PLIERS
(7) Install UD clutch piston (Fig. 297).
Fig. 297 Underdrive Clutch Piston
1 - PISTON
LH