Installation - Chrysler Concorde 2004 Service Manual

LH
LOCK CYLINDER HOUSING (Continued)
(7) Lift off multifunction switch, then disconnect
two wiring connectors and remove switch.
(8) Remove two torx-head screws securing ignition
switch in place (Fig. 40). Remove switch from col-
umn. allow switch to hang by wiring harness.
Fig. 40 Ignition Switch Mounting Screws
1 - IGNITION SWITCH
2 - MOUNTING SCREW
3 - STEERING COLUMN
4 - MOUNTING SCREW
5 - MULTIFUNCTION SWITCH
(9) Remove two torx head screws securing lock cyl-
inder housing to column (Fig. 41).
(10) Remove lock cylinder housing from steering
column.

INSTALLATION

(1) Position new lock cylinder housing on steering
column (Fig. 41).
NOTE: In order to correctly seat the lock cylinder
housing to the steering column, the right side
mounting screw (from drivers' in-vehicle position)
must be seated and tightened first as outlined in
the following steps.
(2) Install and tighten new right side mounting
screw to 10 N·m (89 in. lbs.) torque.
(3) Install and tighten new left side mounting
screw to 10 N·m (89 in. lbs.) torque.
Fig. 41 Lock Cylinder Housing Mounting
1 - SCREWS
2 - STEERING COLUMN
3 - LOCK CYLINDER HOUSING
(4) Install ignition switch. (Refer to 19 - STEER-
ING/COLUMN/IGNITION SWITCH - INSTALLA-
TION)
(5) Install multi-function switch. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
MULTI-FUNCTION SWITCH - INSTALLATION)
(6) Attach wiring harness in place on left side of
column using nut.
(7) Install a new shift interlock cassette. If the
vehicle has a floor shift, reconnect and adjust the
shift cable as necessary.
(8) If equipped with Sentry Key Imobilizer System,
install SKIM. (Refer to 8 - ELECTRICAL/ELEC-
TRONIC CONTROL
IMMOBILIZER MODULE - INSTALLATION)
(9) Install upper
shrouds, and tilt lever. (Refer to 19 - STEERING/
COLUMN/LOWER SHROUD - INSTALLATION)
(10) Connect remote battery ground cable to stud
at right strut tower.
(11) Check operation of key cylinder, lock housing
and ignition switch.
COLUMN 19 - 27
- EXTERIOR/
MODULES/SENTRY
and lower steering
KEY
column