Suzuki Wagon R Manual page 2546

Direct Clutch Return Spring Subassembly
Measure free length of direct clutch return spring.
Free length of direct clutch return spring
"a": 36.04 mm (1.419 in.)
NOTE:
• Do not apply excessive force when measuring spring
free length.
• Perform measurement at several points.
Direct Clutch Piston
Shake direct clutch piston lightly and check that check ball (1) is
not stuck. Blow in low-pressure air (Max 100 kPa, 1 kg/cm
psi) to check ball to check that there is no air leakage.
Assembly
Reverse disassembly procedure for assembly, noting the following
points.
• Use new seal ring and O-ring. Apply A/T fluid before installa-
tion.
• Do not damage direct clutch return spring subassembly (1)
and piston by pressing in direct clutch return spring subas-
sembly passing through its original installing position over
0.7 mm (0.027 in.).
Special tool
(A): 09926-98310
• Apply A/T fluid to direct clutch separator plates (4), discs (3)
and retaining plate (2).
• Install direct clutch separator plates (4) discs (3) retaining
plate (2) and snap ring (1) to input shaft subassembly.
AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-149
2
, 15