Table of Contents
Advertisement
NOTE:
For vehicles sold in Canada, rotate the headlight switch
clockwise from the parking light and instrument panel
light position to the first detent to turn on the head-
lights also. Rotate to the second detent, AUTO position,
to turn on automatic headlights, parking lights, and
instrument panel lights.
DAYTIME RUNNING LIGHTS (DRLS)
— IF EQUIPPED
The headlights or LED light bars on your vehicle will
illuminate when the engine is started. This provides a
constant lights on condition until the ignition is placed
in the OFF position. If the parking brake is applied, the
Daytime Running Lights (DRLs) will turn off.
NOTE:
•
For vehicles sold in Canada, the Daytime Running
Lights will automatically deactivate when the front
fog lights are turned on.
•
If allowed by law in the country in which the vehicle
was purchased, the Daytime Running Lights can be
turned on or off using the Uconnect system
page 169.
•
On some vehicles, the Daytime Running Lights may
deactivate, or reduce intensity, on one side of the
vehicle (when a turn signal is activated on that
side), or on both sides of the vehicle (when the haz-
ard warning lights are activated).
HIGH/LOW BEAM SWITCH
Push the multifunction lever toward the instrument
panel to switch the headlights to high beams. Pulling
the multifunction lever back will turn the low beams on.
AUTOMATIC HIGH BEAM —
IF EQUIPPED
The Automatic High Beam system provides increased
forward lighting at night by automatically controlling the
high beams through the use of a camera mounted on
the windshield. This camera detects vehicle specific
light and automatically switches from high beams to
low beams until the approaching vehicle is out of view.
NOTE:
Broken, muddy, or obstructed headlights and taillights
of vehicles in the field of view will cause headlights to
remain on longer (closer to the vehicle). Also, dirt, film
and other obstructions on the windshield or camera
lens will cause the system to function improperly.
To Activate
1. Select "Auto Dim High Beams" through the
Uconnect system to enable the feature
page 169.
2. Rotate the headlight switch clockwise to the AUTO
position.
3. Push the multifunction lever away from you to switch
the headlights to the high beam position. Refer to
"Multifunction Lever" in this section for further
information.
GETTING TO KNOW YOUR VEHICLE
NOTE:
This system will not activate until the vehicle is at, or
above 16 mph (25 km/h).
To Deactivate
Perform either of the following steps to deactivate the
Automatic High Beam system.
1. Deselect "Auto Dim High Beams" through the
Uconnect system
page 169.
2. Pull the multifunction lever toward you to switch the
headlights from the high beam to the low beam
position.
3. Rotate the headlight switch counterclockwise from
the AUTO to the on position.
NOTE:
Once active, the Automatic High Beam system will stop
functioning below 12 mph (20 km/h).
FLASH-TO-PASS
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will cause the high beam headlights to turn on, and
remain on, until the lever is released.
63
2
Advertisement
Table of Contents
