Input Settings Screen - Ikegami ML Series User Manual

6. Configuration
・H/V.Size
・Dot Clock
・Clock Phase
・ Auto Adjust
6.5 Settings screen
Function to set the signal format, etc.
Screen display
・RGB/YpbPr HD15 : Setting of signal format of HD15 input. RGB or YPbPr can be
DVI-D : Setting of signal format of DVI-D input. RGB or YPbPr can be
・DVI EQ
・ Fmt Sensitivity
: Used to adjust the horizontal and vertical sizes onscreen.
Move toward the plus side to enlarge the screen.
Move toward the minus side to reduce the screen.
: Adjusts the number of sampling dots of the HD15 analog signal.
The sampling frequency increases/decreases with "+" and "-"
respectively. Adjust when vertical stripes and noise occur on the
screen.
: Adjusts the sampling point of the analog signal of PC input.
Adjust when the base section of the letters is unclear or when the
noise appears when fine patterns are displayed.
: Automatically adjusts the display position and the size, the
number of sampled dots, and the sampling point, depending on
the input signal.
set.
set.
: Cable correction function when a long cable is used.
"Auto" is the automatic correction. If noise remains with "Auto,"
remove noise by switching to "Low," "Middle," or "High."
: The signal detection operation speed can be set.
Slow : When the signal interruption is detected consecutively, the
signal interruption process is conducted.
It is effective when the device is used in an environment
with much noise.
Fast : After a detection of signal interruption, the signal
interruption process is immediately conducted.
14