Color Settings Screen - Ikegami ML Series User Manual

6. Configuration
・ BackLight
・Select
・Sharpness
・ Noise Reduction
・ Video Setup
・Low Latency
DICE Whit
・DICE Black

6.3 Color Settings screen

Function to adjust the display color.
Screen display
: Adjusts the colors of the video.
・Hue
: Adjusts the color density of the video.
・Chroma
: Switches between color/monochrome. "On" is the monochrome mode.
・Mono
・Color Temp. : Sets the color temperature.
6,500 degree / 9,300 degree / Native can be set. "User" is approximately
7,200 degree.
: 1.8 to 2.6 and simplified DICOM14 are selectable.
・Gamma
・Color Space : BT709, DCI, AdobeRGB, and Native are selectable.
"Native" is the color range of the LCD panel without correction.
In case of 26 type, DCI and AdobeRGB are not selectable.
・Red Gain : Adjusts the intensity of red color in the highlight section.
・Green Gain : Adjusts the intensity of green color in the highlight section.
・ Blue Gain : Adjusts the intensity of blue color in the highlight section.
: Used to change the backlight brightness of the LCD panel.
The adjustable range is from 0 to 20. (26-inch up to 18)
: Select function of the BackLight brightness.
"Normal" is the standard mode, and "High" is the high-intensity
mode.
: Used to adjust the sharpness.
Increase the setting to get images shaper, and decrease it to get
them softer.
: Used to reduce noises.
The noise reduction effect increases in an order of "Off," "Weak,"
"Middle," and "Strong."
: It will set up the level of the selection of video and S- video signal.
0 : Offset is 0%
High : Offset 7.5%
: "Slow" is the standard mode, and "Fast" is the low delay mode
: Gain adjustment function for the highlight section.
: Gain adjustment function for the Lowlight section.
Hise Enable Off On
12
±15
0-128
5