Datavideo TLM-170V Instruction Manual page 31

3. Establish communication with the "Probe"
After selecting the color calibration device at the second step, we must manually establish
communication between the Probe and the PC.
Select "Tools  Calibration  Calibration Interface or Display Characterization"
The CMS should detect the probe and a dialogue box for COM port selection will pop up. In the
example below, the probe's model number is CR-100.
Select a COM port number for establishing connection with the PC.
4. Connect the TLM-170V monitor
Connect the TLM-170V to the HDMI port of your PC or laptop, power ON the monitor and set the
computer output to the extended output mode. Then open the graphics control panel and set the
PC's HDMI output to RGB full-range.
5. Set the HDMI RGB range on the TLM-170V.
31