Table of Contents
Advertisement
eBUS
Button Panel EU and MK Series • Setup Guide (Continued)
®
Remove the rotary encoder knob
(VC1 models only)
The EBP VC1 EU and EBP VC1 MK have a rotary encoder
knob. Before replacing the buttons, remove the encoder, as
shown here.
EBP VC1 EU and EBP VC1 MK only: Turn the rotary
1.
encoder knob (figure 3,
holding the knob in place (
Insert the provided 0.05 inch Allen wrench and turn the
2.
wrench in the direction shown (
Pull the knob straight out to remove it.
3.
Once the encoder knob is removed, removing the faceplate
and replacing the buttons is the same for all models.
Remove the bezel (except the EBP 104 EU and
EBP 104 MK)
Insert the Extron pry tool into the gap between one side of the
bezel and the frame. Release the locking tab holding the bezel
to the metal mounting bracket (figure 4,
catch in the middle of each side. If necessary, use the pry tool
to release the second catch on the opposite side.
The frame is held in place by the bezel. When the bezel is
removed, the frame also comes away from the wall. Pull the
device and the frame away from the wall.
Remove the bezel on the EBP 104 EU or
EBP 104 MK
The EBP 104EU and EBP 104MK have two locking tabs
at the top and two more at the bottom.
Insert the Extron pry tool between the top of the bezel
and the frame and slide it to the location of one of the
locking tabs (see figure 5,
that the locking tab is pressed down, which releases it
(
2
).
When the first catch is released, slide the pry tool along
the gap between the bezel and the frame to release the
second catch.
If necessary, use the pry tool to release the catches on
the bottom of the bezel.
Tip the bezel forward and remove it (
held in place by the bezel. When the bezel is removed,
the frame will also come away from the wall. Pull the
device and the frame away from the wall.
4
1
) to expose the hex screw
2
).
3
) to loosen the screw.
1
). There is a single
1
). Pull the pry tool up so
3
). The frame is
1
Turn Knob to
Expose Screw
Remove the Rotary Encoder (VC1 models only)
Figure 3.
Y
1 1
L A
S P
D I
F
O F
M E
O N
L U
V O
O P
P T
L A
E O
V I D
Release Bezel
Figure 4.
Pry Tool
C E
U R
S O
2
C E
U R
S O
1
T E
M U
C E
U R
S O
3
At the locking tab
2
1
locations, insert the
pry tool up to the
line below the arrow.
Release Bezel (EBP 104 EU or EBP 104 MK)
Figure 5.
3
Use Allen Wrench
to Loosen Screw
2
Insert
to line.
Locking
Tabs (2)
C E
U R
S O
2
C E
U R
S O
1
T E
M U
C E
U R
S O
3
Pull the pry tool to the
Remove the
3
left to unhook each
module.
locking tab from the
mounting bracket.
Advertisement
Table of Contents
