Table of Contents
Advertisement
Mounting EBP EU Devices in a Raceway
NOTES:
•
If there is a gap between the metal mounting bracket and the wall frame, insert the provided raceway spacer between
the mounting bracket and the rim of the junction box (see figure 16).
The spacer looks very similar to the metal mounting bracket, but has a slightly larger center opening, has holes
instead of slots for the mounting screws, and is engraved with the words "Optional Spacer" and "Place behind
bracket."
•
Do not use the spacer instead of the metal mounting bracket. The spacer has a larger opening and will not hold the
EBP securely in the wall frame.
To mount the EBP EU to a raceway using the spacer:
Mount an electrical box in the raceway (Figure 16,
1.
Follow the instructions provided by the manufacturer.
If required, align the screw holes of the provided spacer
2.
with the holes in the electrical box (
Align the screw holes in the metal bracket with the holes
3.
in the spacer and electrical box (
NOTE: Ensure that the front surface of the mounting
bracket is facing out (away from the wall).
Secure the metal bracket and spacer to the junction box,
4.
using the two provided screws (
heads protruding approximately 1/8 inch (3.18 mm) from
the surface of the spacer.
Rotate the metal bracket as necessary to ensure that the
5.
EBP will be aligned correctly on the mounting surface.
Tighten the screws to secure the bracket to the spacer.
6.
Disconnect power from all devices at the source and
7.
run cables through the raceway, junction box, spacer,
bracket and frame. Connect them to the rear panel
captive screw connectors (see
Devices
on page 9).
If you have not already done so, set the DIP switches to
8.
give the panel a unique eBUS ID (See
eBUS ID on page
6).
Insert the EBP into the wallplate (
9.
entire assembly into the metal bracket (
is secured to the metal bracket by two catches (one on
each side) and holds the frame in place.
NOTE: The EBP 104 EU and EBP 104 MK are held in
place by four catches, two on the top and two on
the bottom.
Junction Box
1
).
2
).
3
).
4
). Leave the screw
Figure 16.
Step 5: Cable All
Step 4: Set the
5
) and press the
6
). The EBP
1 1
2 2
Raceway Spacer
3 3
Mounting Bracket
Mounting Bracket
6 6
Cable Raceway
Mounting in an EU Raceway with Spacer
Product Category
4 4
Frame
Frame
5
Y
L A
S P
D I
F
O F
M E
O N
L U
V O
P C
EBP 106 EU
EBP 106 EU
13
Advertisement
Table of Contents
