Removing Ebp Eu Or Mk Wallplates - Extron electronics eBUS Button Panel EU Series Setup Manual

eBUS Button Panel EU and MK Series • Setup Guide (Continued)
®

Removing EBP EU or MK Wallplates

If you need to remove an EBP EU or MK wallplate from where it is
mounted, follow these steps:
Insert the provided Extron removal tool into the gap between
1.
the side of the button plate and the frame (figure 17,
The tip of the tool should be inserted to the depth of the line
marked on the tool.
Slide the removal tool along the gap until the catch on the
2.
side of the button plate (
If necessary, repeat steps 1 and 2 to release the other side of
3.
the button plate.
NOTE: The EBP 104 EU and EBP 104 MK are held in
place by four catches, two on the top and two on the
bottom and are removed by a different procedure (see
Remove the bezel on the EBP 104 EU or EBP 104
MK
on page 4).
Pull the EBP away from the frame. The frame is released at
4.
the same time.
Remove cables.
5.
Remove the screws holding the metal bracket to the wall box
6.
( 3 )
© 2016 - 2018 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
14
1
2
) is released.
).
Wall Box
Mounting Bracket
Removing the EBP 106 EU
Figure 17.
1 1
Y
L A
S P
D I
F
O F
M E
O N
L U
V O
O P
Insert
P T
L A
to line.
E O
V I D
3 3
Y
L A
S P
D I
F
O F
M E
O N
L U
V O
2 2
Frame
P C
EBP 106 EU
www.extron.com
68-1449-50 Rev. C
03 18