Approvals And Certifications; Symbols, Abbreviations, And Conventions - Danfoss CANopen VLT Midi Drive FC 280 Programming Manual

Introduction
1 1

1.5 Approvals and Certifications

More approvals and certifications are available. For more
information, contact a local Danfoss partner.
1.6 Symbols, Abbreviations, and
Conventions
Abbreviation
CAN
CiA
COB
COB-ID
CTW
EDS
EMC
EMCY
I/O
LCP
LED
LOP
LSB
MAV
MRV
MSB
NMT
N/A
OD
PCD
PDO
PLC
PNU
REC
RPDO
RPM
RTR
RX
STW
SDO
SYNC
TEC
TPDO
TX
Table 1.2 Symbols and Abbreviations
4
CANopen
Definition
Controller area network
CAN in automation
Communication object
Communication object identifier
Control word
Electronic datasheet
Electromagnetic compatibility
Emergency message
Input/output
Local control panel
Light emitting diode
Local operation pad
Least significant bit
Main actual value (actual output)
Main reference value
Most significant bit
Network management
Not applicable
Object directory
Process data
Process data object
Programmable logic controller
Parameter number
Receive error counter
Receive process data object
Revolutions per minute; unit for the speed of a
revolving motor
Remote transmission request frame
Receive data
Status word
Service data object
Object for synchronization of process data
Transmit error counter
Transmit process data object
Transmit data
Danfoss A/S © 02/2016 All rights reserved.
®
Conventions
Numbered lists indicate procedures.
Bullet lists indicate other information and description of
illustrations.
Italicized text indicates:
•
Cross-reference.
•
Link.
•
Parameter name.
•
Footnote.
•
Parameter group.
•
Parameter option.
•
Alarms/warnings.
MG07E102