RGBlink X3 User Manual page 45

3D-Mode
Click the "3D-Mode", and pop-up window as follows:
Click "OK", the system will synchronize the data, and it will finish about 5 seconds later, click "OK",
it will enter the interface as follows:
Default 2D-Mode, right click the signal, and select "Set Input 3D Type", it will enter the interface
as follows:
User can select "3D-Mode One InputSource" or "3D-Mode Two InputSource". If select "3D-Mode
One InputSource", it will show "3D" on the signal, as shown in the figure below:
If select "3D-Mode Two InputSource", it will show "3D-1" and "3D-2" on the signal, as shown in
the figure below:
X3 User Manual
44