RGBlink X3 User Manual page 54

If select "Net Connect" and "Search by this configuration", the software will search all the devices
with corresponding IP.
System Information
Click the "System Information", and pop-up window as follows:
Display the software version information. Including device model, serial number, IP address,
firmware version, etc.
IP Settings
Click the "IP Settings", and pop-up window as follows:
Default "Auto get ip address". Users can also set IP address, mask and gateway manually. This is
usually used if one computer control some devices or remote control. It takes effect after reboot
the software if change IP through network.
Factory Reset
Click the "Factory Reset", and pop-up window as follows:
X3 User Manual
53